Showing posts with label home decor. Show all posts
Showing posts with label home decor. Show all posts

Sunday, February 10, 2013

Rolled Rosette Variation Tutorial

These are a very cute embellishment, very easy to make, and they are a great way to use up some of that scrap fabric you may accumulate over time. I'll be making a May Day wreath with these later on!

You will need: three 1 in. x 20 in. strips of fabric (these don't need to be perfect by any means), a felt circle about 2 in. across, hot glue gun

1. Stack your fabric strips on top if each other, print facing up.

2. Tie a knot at one end.

3. Use something heavy to hold the knot to a flat surface.

4. Braid the three strips together, keeping the same tension the whole way to keep the braid close to the same width the entire length. (I say this because I'm terrible at it. Thankfully these are very forgiving)

5. When you have about 2 in. of fabric left, tie a knot to finish your braid, pulling it tight. Trim any excess.

6. Glue one of the knots down in the middle of the felt circle. Wrap the braid around the knot. Keep wrapping the braid tightly around itself, using a drop of glue about every half inch between the braid and the felt circle. Keep wrapping until you come to the end knot, which you can glue to the side of the braid.

7. If your felt circle is sticking out, trim off the excess. My circle was wonky, so I had to trim.

You've seen these rosettes in my fab headband tutorial. I love that I can use scraps to make them and they are completely no-sew!

Very Simple Hair Bow Holder Tutorial

Do your girls have a ton of bows and no where to put them? Don't want to pay the exorbitant prices some boutiques charge for a hair bow holder? Then this tutorial is for you. These are ridiculously simple AND cheap to make.

You will need: one pre-painted layered wood cutout in the shape of your choosing (You can find these in the woods aisles at most craft stores and at just about any store with a craft section. They come in about every shape you could think of, so you can match them to the decor of the room where they will hang), 1 yd 7/8 in. ribbon that coordinates with your cutout (grosgrain is preferable), about 8 in. of 1/8 in. grosgrain or satin ribbon, hot glue

1. Seal the ends of your 7/8 in. ribbon. Seal the ends of the 1/8 in ribbon.

2. Tie the 1/8 in. ribbon in a bow (shoe laces style). Secure the bow with a little dot of hot glue on the back (less cute) side.

3. Turn your cutout face down. Hold your 1/8 in bow up to the top, glue down the  tails of your bow so that it keeps it's natural triangle between the  cutout and the bunny ears part of the bow. It's important to make sure the bow is centered before applying the glue. This allows your bow holder to hang straight.

4. Center the 7/8 in. ribbon in the middle towards the bottom of the cutout. Using a small button sized dot of hot glue, stick the ribbon down.

5. Let glue set for a few minutes and you're ready to hang your bow holder! Use a thumb tack to avoid large holes in the wall.

6. Hang your bow stash on the 7/8 in. ribbon. Open the bow clips and clip to the ribbon. If you use grosgrain ribbon, the bows shouldn't slide, even if they're large.

Ta-da! This project only takes a few minutes and costs only about $2 to make.